
Rubber membrane repairs done right the first time
EPDM Roof Repair in Surrey that stops flat roof leaks
EPDM Roof Repair in Surrey is what we do when a flat or low-slope roof starts dripping into your building. Whether it's a commercial shop on a Ward County lot or a garage with a ponding puddle, we find the failure, patch or re-seam the membrane, and test it before we pack up. One call to +1 844 710 0795 gets a same-day estimate.
What's included
What our EPDM Roof Repair includes
Every EPDM Roof Repair in Surrey starts with a full diagnosis, not a guess. Here's what's covered in a standard repair visit, and what we'll quote separately if your roof needs it.
Full leak diagnosis
We walk the roof with a moisture meter and infrared camera to find wet insulation and the true leak source. You get photos and a written scope before any work starts. This step alone saves you from paying twice for the same leak.
Membrane cleaning and prep
We cut back the failed area, scrub it with splice cleaner and let it dry completely. Dirt and granule loss are the top reasons patches peel. Proper prep is what makes a repair last through a North Dakota winter.
Patch, seam or boot repair
Depending on what failed, we apply a cover tape patch, re-glue a seam with bonding adhesive, or replace a cracked pipe boot. We roll every patch flat and seal the edges with lap sealant.
Flashing and edge re-seal
We check and re-seal flashings, edge metal and terminations while we're up there. Loose flashing is a common leak source on Surrey flat roofs and it's cheap to fix during a repair visit.
Water test and clean-up
We flood-test the repair or run a hose over it for 15 minutes and check from inside. Then we clear the drains, sweep the roof and haul away all scraps. You get a written warranty on the work.
Service overview
What EPDM Roof Repair in Surrey actually involves
EPDM Roof Repair in Surrey means restoring a black rubber membrane roof instead of tearing it off. We inspect the field, seams, flashings and drains, then fix the failure point. Most repairs are a patch over a puncture, a re-glued seam, or a new pipe boot. EPDM is a single-ply rubber sheet, so a small hole can let in a lot of water fast. We use a moisture meter and infrared camera to confirm the leak is where you think it is before we cut anything.
Surrey sits in Ward County, where flat roofs take a beating. Summer sun bakes the membrane, then fall and winter swing from 60 degrees to below zero. That freeze-thaw cycle opens seams and shrinks rubber around pipe boots. We see a lot of EPDM roof leak repair Surrey ND calls after the first hard freeze, and again each spring when snowmelt finds old punctures. If you need EPDM Roofing Repair near me Surrey, we cover the whole city and the surrounding towns.
The service timeline
How our EPDM repair process runs
The process flexes to the condition, but these checkpoints keep decisions clear.
Call and schedule
You call +1 844 710 0795 or book online. We ask what you're seeing: a stain on the ceiling, water pooling on the roof, a seam that's peeled up. We book a same-day estimate and tell you what time we'll be there. No waiting around all day.
Inspect and diagnose
We walk the roof with a moisture meter and infrared camera to find wet insulation. We check seams, flashings, pipe boots and drains. On a typical Surrey flat roof this takes 45 to 90 minutes. You get photos of the problem and a written scope before we start.
Prep the membrane
We cut back the failed area, scrub it with splice cleaner, and let it dry. Loose granules and dirt are the number one reason patches fail. We use a roofing hammer and pry bar to lift edge metal where needed, and a magnetic sweeper to pick up screws before they become punctures.
Patch, seam and seal
We apply bonding adhesive or peel-and-stick cover tape, roll it flat, and seal the edges with lap sealant. Pipe boots get replaced, not patched, if the rubber is cracked. Flashings get re-secured and re-sealed. Most repairs take two to four hours on site.
Water test and clean up
We flood-test the repair area or run a hose over it for 15 minutes and watch from inside. If it's dry, we clean the gutters, sweep the roof, and haul away every scrap. You get a written warranty on the repair and a reminder for your next inspection.
Tools & methods
Tools and methods we use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Moisture meter
Finds wet insulation under the membrane so we know how far the damage spreads. It tells us whether a patch is enough or if a section needs to come out.
Infrared camera
Shows temperature differences that reveal hidden moisture. On a big flat roof it saves hours of guessing and points us straight to the leak source.
Caulking gun and lap sealant
Seals patch edges, flashings and terminations. We use EPDM-compatible sealant so it bonds instead of sitting on top and peeling.
Utility knife and pry bar
Cuts membrane cleanly and lifts edge metal or flashing without tearing the surrounding sheet. Clean cuts are what make a patch sit flat.
Magnetic sweeper
Picks up screws, nails and staples left on the roof. A single screw is a future puncture, so we sweep every roof before we leave.
Roofing ladder and safety harness
Gets us up safely and keeps us tied off while we work. Flat roofs still have edges, and fall protection is non-negotiable on every job.
Use cases
When Surrey properties need EPDM repair
These examples show how the service framework adapts rather than forcing every call through one repair.

Newton garage puddle drained and sealed
A homeowner had a permanent puddle on the garage roof and a musty smell inside. The drain was clogged with leaves and the membrane had a small puncture under the water line. → We cleared the drain, patched the puncture with cover tape, and re-sealed two seams. The puddle drained within an hour. The smell cleared once the insulation dried.
Cloverdale apartment building seam repair
A property manager had three units reporting ceiling drips after a fall storm. The EPDM roof had multiple open seams along a 40-foot run and loose edge flashing. → We repaired the seams with bonding adhesive, re-secured the edge metal, and replaced two pipe boots. All three units stayed dry through the next rain. The repair cost a fraction of a replacement quote.
Problems we solve
EPDM roof problems we fix in Surrey
Flat roofs fail in predictable ways. Here are the calls we get most often and how we handle them.
Ponding water sitting on the membrane
We clear the drains, check the slope and repair any seam the ponding has opened. If the roof holds water because of a low spot, we'll tell you straight whether re-pitching or a new drain is the fix.
Peeled or failed seams
We clean the seam, apply bonding adhesive or cover tape, and roll it flat. We also check the rest of the seams on the roof, because if one failed the others are close behind.
Cracked pipe boots and vent leaks
We replace cracked boots with new EPDM-compatible ones and re-seal the base. It's a small repair that prevents a big ceiling stain. We check every penetration while we're on the roof.
Punctures from foot traffic and hail
We patch punctures with cover tape and primer, then sweep the roof with a magnetic sweeper to pick up screws and nails before they cause the next one.
Pricing process
EPDM Roof Repair pricing in Surrey
$350 - $1,800 depending on scope
Size of the repair
A single patch takes an hour; a 40-foot seam re-do takes most of a day. The more membrane we have to clean, prep and seal, the more labor and material it takes. Size is the biggest driver of cost.
Roof access
A low garage roof is quick to get on. A tall commercial building needs ladders, harnesses and sometimes a lift. Hard access adds time and equipment to the job, and that shows up in the price.
Wet insulation
If the leak has soaked the insulation, we have to cut it out and replace it before the patch goes down. That's extra material and disposal. Catching a leak early keeps this cost off the bill.
How much does EPDM roof repair cost in Surrey ND?
Most EPDM roof repairs in Surrey run $350 to $1,800 depending on size and access. A single pipe boot replacement is on the low end; a large seam re-do with wet insulation removal is higher. We give you a written scope with photos before we start, so there are no surprises. Call +1 844 710 0795 for a same-day estimate.
Can you repair an EPDM roof in Surrey North Dakota?
Yes. We repair EPDM membranes across Surrey and Ward County year-round. In October we work around the first freeze; in winter we do emergency tarp-overs and schedule permanent repairs for a warm stretch. EPDM adhesives need dry membrane and 40 degrees or better, so we plan around the forecast.
How long does EPDM roof repair last in Surrey ND?
A properly installed patch or seam repair on a sound EPDM membrane lasts 8 to 12 years with annual maintenance. The key is fixing the cause, not just the symptom. If the membrane is brittle or the insulation is soaked, we'll tell you straight whether a repair makes sense or if replacement is the better money.
Who does EPDM roofing repair near me in Surrey?
We do. Surrey Roof Repair handles EPDM Roofing Repair near me Surrey calls from Whalley to Cloverdale and everywhere in between. We're licensed in North Dakota, insured, and we carry EPDM materials on the truck. One call to +1 844 710 0795 and we'll get you on the schedule, usually same day.
Ready when you are
Get your EPDM Roof Repair in Surrey scheduled today
Water on the ceiling won't wait for a convenient time. Call +1 844 710 0795 and we'll get an estimator on your roof, usually the same day. Licensed, insured and warrantied work across Surrey and Ward County.

Talk with the local team
Request EPDM Roof Repair
Call us at +18447100795 or email [email protected]. We answer the phone 24/7 for emergencies and schedule regular inspections within one business day. If you have photos of the damage, send them over and we can often give you a ballpark before we arrive.



